DEFORMATION SENSOR
Easy intallation and calibration..
Sensor made with iron high-resistance, little size (90x25x20h mm).
Directly application at beam or mechanical structure.
Without modify at structure existent.
High sensibility.
Good accuracy.
Standard cable 700 mm, 5 wires.
Protection at umidity, temperature, dust.
Supplied with screw-kit.
ELECTRONIC DEVICE
Electronic part with all digital command, no trimmer or analogic regulation.
Supplied with 1...4 programmable set-point (the X is the number of set-point).
The electronic part is supplied with box and pratical cover (without screw).
Little size 120x110x30h mm, with fixed point.
The memorization of zero and set-point, is make with only push-button.
The electronic have the led indicator, with that is possible control the correct procedure.
The power applicable are continuos mode or alternate mode.
Possibility of percentual calibration, with small load make a calibration of big set-point.
Possibility of modify set-point, without load.
Electronic part with digital port serial-out (other application).
Supplied with a little connector or board for the analogic output.
Electronic part with analog out 0…10Vcc, for feedback of inverter.
Supplied with a connector for the remote control part.
Programmable on board or with remote tool.